Clone-A-Willy DIY Homemade Dildo Kit Jet Black

This kit thankfully comes with a second bag of the mold incase you mess up. If this is your first time using it like me you’ll probably mess up. But with an extra mold bag just pay attention to your mistakes. Time is 💯 crucial along with the water temperature. Pay special attention to both. If you have a large member I’d definitely recommend getting this kit over the regular one just because the clone without balls does not include enough of the silicone to get the job done

She loves it

I’m blessed. But I’m also under 9 inches. I didn’t account for thickness and lost 2” from my mold. I would have bought the thicker vibrator but the site says one would want the larger vibrator for 9” +. Bummed not to get the full mold of my down below. Perhaps I’ll try again another time and get some extra silicone mix

Im going to be honest i wasnt happy with it as i hoped i think the cylinder needs to be bigger because when my dick was hard it was pointing more upwards and the clyinder could not tilt tht high with the balls cup so it was hard trying not to spill it n also keeping my dick hard while trying to make sure the mold was covering it. My dick would touch top of cylinder. And i put the 7in vibrator in for my girl and portions were showing after the mold settled i think u guys should make a powerful 3 speed vibrator that fit most dick sizes and gerths that can be put inside that little tiny one it comes with doesnt compare to the pleasure of the 7in xl one.

Todd was able to help me with my request, and the store is very thankful. We will continue to carry your products.

The quality and detail that the clone a willy does offer is amazing and it’s a really easy process to complete. My only problems are it says you can use it to make candles and popsicles but the mold doesn’t last very long after first use to make anything else or multiple popsicles. We do really like them and will probably buy more to make more

My wife and I jave done the kit twice and it was so much fun that we bought some fornour friends!

My hubby and I had a lot of fun making it, but I highly recommend doing it over newspapers or on a tile floor, as it can be quite messy. We waited a full day between making the cast and filling it with the silicon because the cast was very wet and we didn't want to have air bubbles in the final product. Placing the vibrator was the hardest part because it was hard to tell where it was sitting inside the silicon, but it ended up working perfectly! I don't understand why so many people said this was difficult. We had no problems at all and had to do very little "research" before we were confident we could do it. I used my shaker bottle for the mold powder and it was mixed well in plenty of time to get it into the tube and situate my husband in it. The whole process was easy and entertaining and we were laughing the whole time. Just read the instructions a couple times before you start!

It was great

So much fun!